Checking to interaction diagram

This item defines the type of selection that the user wants to use to choose beams where the design results should be displayed.

Selects the type of load to be evaluated: load case, combination, class.

Selects the particular load case, combination or class to be evaluated.

The selection of beams to be evaluated may be filtered out.

If ON, a table explaining warning and error occurring the design is attached to the document. This item has no response in the graphical window.

This item selects the value or values to be displayed. See below.

Extreme value {default} – the  selected value is presented in the graphical window and the extreme value in the numerical output is based on the maximum  check value of the selected value

Extreme check value  - the check of selected value is presented in the graphical window and the extreme value in the numerical output is based on the maximum check value of the selected value

Defines the places where numerical values will be added to the diagram of selected quantity.

Enables the user to adjust the display style for the result diagrams. See below.

All

The checks are performed and displayed in all sections along the member. The number of sections is defined in Solver setup.

Input

The checks are performed and displayed ONLY in sections defined by the user. The sections can be defined in service Structure.

Ends

The checks are performed and displayed ONLY in end points of the member.

Input + Ends

The checks are performed and displayed in sections defined by the user and in the end points of the member. The sections can be defined in service Structure.

the assessment by means of relative value.

ultimate axial force

ultimate shear force

ultimate bending moment My

ultimate bending moment Mz

If ON, labels are attached to the diagram.

If OFF, only the diagram without any description is displayed.

If ON, the longitudinal position of the section is depicted.

The design is always performed for the selected load case or combination. The number of considered load case / combination may be added to the diagram label.

If ON, the number of a potential warning or error is attached to the diagram of selected quantity. If no error occurs, nothing is printed.

Refreshes the contents of the graphical window. Whenever the refresh of the screen is required, this item is red-highlighted.

Shows information about the calculation. See Calculation info for design.

Enables the user to modify design parameters. See Concrete setup for design of beams.

Performs a detailed check of a selected beam. See separate chapter.

Shows the selected design values in the Preview window.