Single check for design of beams

The user may select the section of the beam that should be calculated.

This group shows internal forces in the selected section, enables the user to change the settings and calculate the results.

The designed beam is shown. Mouse cursor may be used to select the required section for assessment.

Pop-up menu may be used to control the view adjustment.

The set of graphical windows presents all the important information related to the design.

Pop-up menu may be used to control the view adjustment.

Any comments accompanying the calculation are listed in this window.

Filtered dialogue for adjustment of design parameters is opened on the screen.

Selects the extreme force for which the cross-section should be checked.

Lists internal forces in the selected section.

If ON, the user may modify the internal forces manually.

Performs the calculation.

Shows the cross-section, its dimensions and the designed reinforcement.

Shows internal forces in the selected section.

Shows the strain and its distribution across the section.

Shows the stress and its distribution across the section.

Shows the strain and its distribution across the section in a 3D view.

Shows the stress and its distribution across the section in a 3D view.

Shows internal forces in the selected section in a 3D view.

Shows the stress-strain diagram for the selected section. The user may click a point in the section (in the left hand side part of the graphical window) or reinforcement and see the corresponding position on the diagram (in the right hand side part of the graphical window).