Open topic with navigation

Making a new connection

The procedure for the definition of a new connection is similar for all analysis types. This chapter presents the general procedure. The following chapters then deal with some specifics of individual connection types.

Note: The connection may also be inserted into an intersection of two or more beams where linked node has been generated.

The general procedure for the definition of a new connection

1. In the graphical window of SCIA Engineer display the part of the structure where the new connection is supposed to be located. Make especially sure that the appropriate node and beams forming the connection can be clearly seen and easily selected.

2. Start appropriate function for the required type of connection either using menu function Tree > Steel > Connections > xxx or using tree menu function Steel > Connections > xxx, where xxx can be one of the following:

   1. Frame bolted / welded - strong axis,

   2. Frame bolted / welded - weak axis,

   3. Grid pinned,

   4. Bolted diagonal.

3. Select the node where the connection is supposed to be designed.

4. The program automatically selects all the beams that come to or pass through the selected node. If required, deselect any of the beams.

5. Press [Esc] to close the function.

6. The program automatically creates the connection in the selected node. The type of the connection depends on geometrical conditions and adjusted priorities.

7. The property window displays all the parameters that are relevant to the specific type of connection.

8. Adjust the parameters of the generated connection in the property window.

9. Clear the selection to finish the design of the particular connection.

Open topic with navigation