Angle of shear reinforcement

There are differences in using of angle of shear reinforcement in calculation between design of reinforcement and check.

• Design - angle of shear force for member = Beam, can be set directly in Concrete setting (if 1D concrete member data is not defined) or in 1D concrete member data , see pictures below. For member = Column, the angle most shear reinforcement is always 90 ° and can not be changed.

Concrete setting	1D concrete member data

• Check - angle of stirrups is loaded from inputted shear reinforcement. There is possible to input shear reinforcement only with angle 90 ° in SCIA Engineer

Type of member can be defined in properties of member via parameter Type or directly in 1D concrete member data