Free line load

Is used for the identification of the load.

Specifies the base direction of the load.

The load may be a force load.

The load may be either constant along the edge or linearly variable (trapezoidal).

Specifies the size of the load.

Defines the validity of the load – see chapter Introduction to free loads for more information.

It is possible to define if all suitable members will be subject to this load or if only selected members are supposed to be affected by this particular load.

Defines the co-ordinate system in which the load is applied.

Specifies whether the load is "put directly on an inclined member" or whether the "projection on plan" is defined.

(Applicable only for loads defined in GCS system).