Construction stages setup
The Setup dialogue for Construction stages enables you to input the default values of the parameters that appear in the input dialogues for individual construction stages.
Type
Currently in version SCIA Engineer 24.0 it is possible to use just Linear construction stages.
Load factors
Results
Specifies the mask for the automatic generation of names of maximal load case combinations. |
|
Name of generated ultimate combination (min) |
Specifies the mask for the automatic generation of names of minimal load case combinations. |
Name of generated serviceability combination |
Specifies the mask for the automatic generation of names of serviceability load case combinations. |
Note: Concerning the generated names of load case combinations, the sequence {O} is substituted with the appropriate number during the generation of the combinations. For example, the combination name mask F{O}-MAX gives combinations named F1-MAX, F2-MAX, F3-MAX, etc.
Procedure to adjust Construction stages parameters
-
Open the service Construction stages.
-
Start function Setup.
-
Input the required parameters.
-
Confirm with [OK].
-
Close the Setup dialogue.