Inserting a new borehole

Procedure to define a new borehole

  1. Open Input panel: Borehole profile.

  2. Start function Borehole profile.

  3. Fill in the parameters.

  4. Confirm with [OK].

  5. Define the location of the new borehole or boreholes.

Borehole parameters

Name

Identifies the borehole profile.
Coord X, Y, Z Coordinates of the inserting point of the borehole.

Results only

When the calculation is performed, you can obtain a table of settlement. The values of settlement are calculated in places where boreholes are located. The borehole itself (the corresponding geologic profile) is also used as an input value for the calculation of interaction between the structure and the soil.

However, it is possible to exclude some boreholes from the input data and use them only as the location for the calculation of results – settlement.

If this parameter is ON, the geologic profile defined in the borehole is ignored, the conditions in this place are interpolated from surrounding boreholes, but final settlement is calculated in this location.

Geologic profile

Specifies the geologic profile corresponding to the location of the borehole.
Sand-gravel pile Defines if the borehole is used as a sand-gravel pile.
Radius Specifies the radius of sand-gravel pile.