Name
Is used for identification of the load.
Type
Outside
The pipe is exposed to external pressure.
Inside
The pipe is exposed to internal pressure.
Distribution
Uniform
The uniform pressure acts on the pipe.
Trapez
The pressure has trapezoidal distribution.
Value – P
(only for uniform distribution)
Specifies the magnitude of the pressure.
Value – P1, P2
(only for trapezoidal distribution)
Specify the magnitude of the pressure.
Close begin
If ON, the pipe is closed at the starting point. This option has an effect on the calculation algorithm.
Close end
If ON, the pipe is closed at the end-point. This option has an effect on the calculation algorithm.
