Open topic with navigation

Adjusting the member data

Member data may be assigned to any member in the structure. Once assigned, they overload default settings made in the Setup dialogue.

The procedure to adjust member data

1. Open service Concrete Advanced.

2. Start function Member data.

   1. for beams use function 1D design > Member data,

   2. for slabs use function 2D design > Member data.

3. Select the member where the data should be assigned.

4. The program takes the shape of member’s cross-section and displays appropriate dialogue.

5. If required, choose the Basic or Advanced mode of the dialogue.

6. Adjust the required parameters. Look at the drawing on the left for explanation of main parameters.

7. Alternatively, you may use button [Load default values] to reload the values adjusted in the Setup dialogue.

8. Confirm with [OK].

Note: For 2D members, if a plate contains subregions, it is possible to assign different member data to individual subregions.

 Member data on a slab

 Member data on a beam

Open topic with navigation